Mining Cap Lamp KL6LM Digital Cordless 15,000 Lux
The KL6LM Mining Cap Lamp Digital Cordless is a cordless, portable and digital miners cap light with time & battery display.
Model KL6LM
3 Lighting Modes
One piece complete unit NO CORDS
Product Description
1. Light Source :
1W Cree XP-E2 LED as main light and 2 pieces 3014 SMD LED as auxiliary light 150LM, 15000lux
2. Four light mode: Main LED high bright, Main LED auxiliary light, Auxiliary LED for half bright light, Strong light blink.
3. Lighting time: high bright 16h, half bright 26h, auxiliary light 100h, strong light blink in last 1 hour.
4. Reliability: semi-clear frosted PC housing ,impact-resistant, corrosion-resistant and waterproof.
5. Security: Integrated explosion proof design, with Impact construction which can prevent overcharging and over discharging.
6. Energy saving: High efficient semi-conductor tec adapted, can save 70% energy than traditional light bulb under same luminescence.
7. Economical: Long life spam light emitting diode, no need maintenance, no extra cost.
8. Environment friendly :Lithium battery with high performance ,memory-less, low self discharge rate.
7. Convenience small size, light weight, lighten users load and Wears comfortable.
9. Uniqueness:
1) Wireless charging technique avoid the bad contact duo to charging port oxidation. Waterproof can also be improved.
2) OLED screen indicate time, work mode, serial number and actual battery balance
Specification:
Comes with C-Tick Charger
Includes GST
1. Press display switch to turn on/ off OLED display.
2. Press lamp switch first time for main light high brightness; Press lamp switch second time for main light half brightness, Press lamp switch third time for backup light.
3.When in any time, press and hold the lamp switch for three seconds, the main light will start flashlight
4.Time and serial number setting:
Press both display switch and lamp switch at the same time for three seconds, the lamp turn to time and serial number setting mode. "Setting" will be shown on the right of the second line of OLED display, and the digit number of "hour" start flashing at the same time, Then press lamp switch to set the number of “hour”. After that press display switch, the digit of “minute” start flashing, press lamp switch to set the number for “minute”. Repeat the above steps to set the numbers of weeks, date and lamp’s serial number. It will be out of the setting mode if no operations was done within 5 seconds.
|
Download the KL6M Miners cap lamp data sheet here. >>>
|
| ||
